High-efficient strong Slag Crusher

1 General Introduction

DGS-XXX series single roller slag crusher is mainly used for the slag crushing of the slag conveying system of power plant. The crusher has reasonable design, compact structure, strong crushing force, high temperature resistance, good airtightness, stable and reliable performance, and the characteristics as auto-control slag discharge, and adjustable slag crushing granularity

The single roller slag crusher can not only be used at wet slag working condition, but also the high temperature dry slag working condition, working together with the dry slag conveyor.

The maximum slag particle size of this series of slag crusher is ≤ 150mm, and the slag discharge particle size is ≤ 30mm


2 Technical Parameter

According to the output, the single roller slag roller can be divided into three types: DGS830, DGS1200 and DGS60A, the respective output is ≤30t/h, ≤40t/hand ≤60t/h

3. Characteristics

Split type bearing pedestal——
Easy to install and maintain. The adjustment error of the concentricity for the main roller shaft is small.

Support by roller wheel——
The whole machine is installed at the roller wheel, which can be moved out along the guide rail if the maintenance is needed, making the maintenance more convenient.

Precision casted high chrome alloy tooth board——
Resistant to temperature high than 450℃, high resistance to wearing, casting appearance error is small.

4.Installation:

The single roll slag crusher is installed on two parallel and horizontal guide rails. The installation of guide rails should not only be relatively flat and aligned, but also be firmly fixed. After being placed on the guide rail, the slag crusher can be pushed and pulled back and forth freely. After aligning the interface position, connect the upper and lower equipment with bolts, and then fix the main body of the slag crusher.

For greater reliability, users can consider adding fixation at the wheels themselves. When connecting the slag crusher to the upper equipment, it is best to use a soft connection or consider the expansion needs of the equipment.

After installing the main equipment, install the proximity switch. Then connect the power cord and signal detection line to the electrical control cabinet, pay attention to the orientation and protection of each cable laying, install the overall equipment completely, and pay attention to oiling and lubrication.